Carbide drawing dies are widely used in drawing metal and non-metal industry. They can be used in drawing steel wires, steel bars, and tubes, etc. And air condition tubes are drawn by carbide floating plug which is a very special drawing tool.
Tungsten carbide drawing die is produced by powder metallurgy with components of tungsten carbide and cobalt. Because of the high wear resistance, excellent polishing, small adhesion, and small friction, our carbide drawing dies can provide a long lifetime.
Types of carbide drawings die
Carbide Wire Drawing Dies
The wire drawing process involves drawing a wire of a larger diameter through a die with a smaller diameter bore. This reduces the diameter of the wire to produce the desired size and tolerance of the wire, while the volume remains the same.
Carbide Bar Drawing Die
Drawing bars and rods is similar to drawing wires, only they tend to be much thicker. A wide variety of metals are used for this purpose, including many steel and copper alloys.
Carbide Tube Drawing Dies
The process is similar to the wire drawing process. However, a mandrel is used to form the inner dimensions of the tubing. The mandrel is placed at the throat of the die and used to determine the wall thickness and inner diameter. A properly formed mandrel will provide for a smooth surface on the inside of the tube or pipe.
Shaped Carbide Drawing Dies
No matter which kind of shape, we can provide customized solutions for you. Here are some typical shaped carbide drawing dies:
- Round Drawing Dies
- Hexagon Drawing Dies
- Square Drawing Dies
- Rectangle Drawing Dies
- Custom Shapes
Typical applications of carbide drawing die
• Steel wire
• Stainless steel wire
• Copper wire
• Aluminum wire
• Tungsten wire
• Various other ferrous and non-ferrous metal wire types
|Excellent wear resistance,suitable for drawing steel,nonferrous metal and alloy wires less than Φ2mm under low stress,especially having better effect for drawing fine wires less than Φ0.6mm.
|Good wear resistance, suitable for drawing steel wires, nonferrous metal wires and alloy wires or bars less than Φ20mm under low stress, also for drawing tubes less than Φ10mm.
|Good wear resistance, suitable for drawing steel wires, nonferrous metal wires and alloy wires or bars less than Φ6mm under low stress.
|Good wear resistance and strength, suitable for drawing steel, nonferrous metal and alloy bars less than Φ35mm.
|Suitable for drawing steel bars and tubes under very high stress.
GooCarbide dies can be relied upon to draw the shape you want within the tolerance required. Special coatings like titanium nitride/titanium carbide or vanadium carbide are available on request to further enhance die life.